Hello Guest it is March 29, 2024, 03:10:21 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - hawk2u

Pages: 1
1
General Mach Discussion / Computer Freezing up only running Mach3
« on: September 15, 2016, 04:22:14 PM »
I set up a dedicated PC for a 3 axis router.  Windows XP,Intel C2D 2.66Ghz, 2GB, 160GB,No internet. Over a year in the build and tinkering stage and the was happy enough to really start to make some things. Till this point I was doing manual input of G-code or files say less than a couple hundred lines. Feeling more comfortable my cut file got much larger. This is when I first started to notice problems, Keyboard freeze, computer freeze, Ghost E-stops are the major things that I remember. I blame it all on the computer and decide to replace it and buy the time I got the bugs out it all the same problems are back within a couple of days trying to run it. I hope someone can point me in a good direction. BTY the original is running fine now that I am not using it on the router.
Hawk 

Pages: 1