Guest
Show Posts
1
General Mach Discussion / Reversed control of the CNC when i use the page up and down. Mach3
« on: August 02, 2016, 05:07:37 PM »
Hi there, i found this forum and wow, this is a lot of information here. My name is Geir Ove, am new here, i am trying to help a friend to set up his CNC after a complete computer crash.
I have done the setup, and i can control the cnc x, y and z axes, but they are reversed, by that i mean, when using page up the cnc is going down, and the same for the arrows, my friend told me that it was not like that before the crash.
I have read a lot of docs, and been looking in the software for something that perhaps "invert" axes or something, but no luck.
Is there anyone that can please point me in a direction? Tank you
Nice forum. Geir Ove
I have done the setup, and i can control the cnc x, y and z axes, but they are reversed, by that i mean, when using page up the cnc is going down, and the same for the arrows, my friend told me that it was not like that before the crash.
I have read a lot of docs, and been looking in the software for something that perhaps "invert" axes or something, but no luck.
Is there anyone that can please point me in a direction? Tank you
Nice forum. Geir Ove