Hello Guest it is March 29, 2024, 12:37:29 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Filby

Pages: 1
1
General Mach Discussion / Mach3 Spindle output stopped working
« on: July 24, 2016, 11:37:13 PM »
Hi,

Just fired up the lathe to do a bit of work and the spindle control has gone. It has been working perfectly fine for about the last 2 years since I put in a VFD to control the motor. Chased the issue all the way back to the pinouts on the parallel port and there is no 4.3v when I turn on the spindle. If I change the same ports that I use for the spindle to say coolant output it switches on and off but when I go back to spindle there is still no output. It seems to be a software issue. Any ideas?


Cheers,

Fil

Pages: 1