1
Newfangled Solutions Mach3 Wizards / New mach 3 lathe setup issue
« on: July 18, 2016, 09:20:25 PM »
Hello everyone, I am new here and have a question. Forgive me if this has been asked before but upon searching I didn't not find an answer. So I setup my sherline lathe with mach and am having an issue with the wizards, they want to start at the center of the part and cut outwards rather than outside to the center. I'm sure it's an easy fix but what am I missing? It's basically acting as if I were printing a part rather than cutting it.
Thanks ahead of time and let me know if you need any more info.
Thanks ahead of time and let me know if you need any more info.