Topics

1

General Mach Discussion / messed up file

« on: July 14, 2016, 11:15:48 PM »

Hello Everyone,
I am pretty new to mach3 and perhaps I am doing something wrong in it, but I am trying to load a tap file generated from dxf by cambam. when I do so and file is fairly simple it appears just fine in mach3. however more complicated file is all messed up and I see in the mach3 display bunch of circles  covering the lines of that file, which supposed to be cut.
can anyone tell me please why is that? and how do I fix it?
I can provide dxf and tap files here if needed.
 thanks a lot in advance.

2

General Mach Discussion / limit switches

« on: July 09, 2016, 02:45:33 PM »

Hello Everyone.
I have tb6560 controller board configured with mach3. I have limit switches set and configured. they are working fine, however, each time the axis reaches the limit switch and upon reseting it, when I try to move axis away from that point, motor makes lot of noise and moves extremely slow. once I moved it enough to unlock limit switch and release the keyboard, and then press the same keyboard key again - it moves with normal speed. can anyone tell me please why is that and how to fix it?
thank you in advance.