1
General Mach Discussion / Pro Cut CNC plasma table help needed?
« on: July 05, 2016, 11:27:40 AM »
Hello, I Purchased a Procut cnc plasma table a few months ago and am in final stages of getting it up and running. Having some issues though. I have every axis running but am having trouble understanding the data interface connection on the back of the plasma. I have a hypertherm model 65. I have attached a schematic to help you see my wiring layout. I am confused about the connection I need to make from the cnc control to the plasma machine interface. I do not currently have a THC so does that mean I only need to connect to interface contacts 3 and 4 (Plasma Arc) or will 12 and 14 (Plasma transfer) need be required as well? Are the connections shown in my schematic correct? That being 3 and 4 are connect to relay at control box and 12 and 14 have a 5v connection and a connection going to #15 on pin out board. Also if I am on the right track Where do I establish these connections in mach pins and ports? Also is there other general configuration settings I need to change for plasma use?