Hello Guest it is November 28, 2021, 07:39:33 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - MC MFG

Pages: 1
1
General Mach Discussion / Ahha driver and Mach 3
« on: March 19, 2006, 12:23:55 AM »
I decided to upgrade my AHHA retrofit from the Artisan software to the Mach 3 controller mostly because i heard good things about constant velocity with Mach 3.  I have had no luck with getting it up and running.  I'm almost 100% sure that the pin outs I have in the instruction manual and have downloaded from the net are not correct for the driver I have!

Can anyone tell me where to get pinouts for a RC500 12-2?  I have customers waiting on parts and my machine is down until I get the new controller to work.

Pages: 1