Topics

1

LazyCam (Beta) / Chains and nodes in lazycam

« on: June 28, 2021, 02:31:39 PM »

Hi, I know is  dead software but is only one that is ridiculously fast and simple for my job . I cut styrofoam profiles.
My problem is image 1 (styrofoam1) after I clean it it remains some extra chains despite that my dxf is one single closed loop.
That happens on windows 7 64 bit PC and on my laptop with Win10 64bit. Same dxf on my other PC with Windows 7 32bit is like image 2 (styrofoam 2)
What can I do to solve the problem on 64bit systems?
I thought it was from windows update and newer c ++ libraries but I tried to install the same ones that are on win7 32bit without luck!
Please help !

2

LazyCam (Beta) / Modifying F value in file exported to Gcode folder

« on: October 27, 2020, 06:13:02 AM »

Hi,
I know is a piece of antique but I'll ask anyway.
I play with LazyCam 3.00 and in exported file is an F1.00 and every time I must change it to my needs by editing that file.
Is there a way to modify this and remain that way?

3

General Mach Discussion / Spindle relay on by M3 command

« on: February 19, 2019, 07:15:07 AM »

Hi ,
I have a TB6560 board and I can control relay (black relay on low right in image atached) with F5 key or with Spindle CW F5 button on Mach3 interface but when I try to put M3 command in my G code nothing happends.
How can I control that relay to work with M3 M5 command?
Thanks

4

General Mach Discussion / Mach3 how to manually moving x axis or y axis very fast

« on: September 10, 2017, 03:42:20 AM »

Hi,
I have some parts to cut from styrofoam and after that is done i want to move hot wire to origin manually (arrow keys)but the speed is very slow.
How can I increase speed? I look everywhere but with no luck. I don't want to change settings in motor tunning because after that I lose calibration .
Please help .
Thanks

5

General Mach Discussion / How to slave motors 2 by 2

« on: June 25, 2016, 02:42:09 PM »

Hi,
I look for a way to slave A to Y and z to X to move sincroneus 2 by 2 motors.I want that to cut styrofoam profiles.
I managed to slave A to Y and X to Z but I want Z to X (when I press X on mach 3 moving direction both motors must move).
Thank you

Ps I have TB6560 driver for 4 motors