Hello Guest it is March 28, 2024, 08:17:24 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Joseph90

Pages: 1
1
Mach3 under Vista / Mach3 backlash compensation
« on: June 04, 2021, 11:08:03 AM »


Hi friends. I would like to know if it is normal that when activating backlash compensation the axes move in a very strange way. I have a .25mm backlash in x and .7mm in Y (very big, I know) but the problem is that when I activate backlash compensation and change direction the movement starts to accelerate and then almost stops and accelerates again. also when I cut a straight figure the cut looks very good but when I make curves or circles it is as if I compensate the backlash by jumps, leaving some steps in the circle or curve. I know that compensating for the backlash in curves doesn't work very well but I don't think it's normal to see steps in the curve. I would appreciate any help.


2
Mach3 under Vista / mach3 constant velocity problem.
« on: June 04, 2021, 09:42:01 AM »


Hi friends. I am writing to you in case you can help me with my problem. I have mach3 v3 on window7, it works fine but constant velocity is not working. no matter how much the settings vary, it always behaves exactly the same. I have a homemade machine and the whole structure is heavy so my accelerations are not very high, constant velocity would allow me to operate at higher speeds. Thanks for your attention.


Pages: 1