1
General Mach Discussion / Fusion 360 and mach3
« on: May 02, 2016, 07:36:05 PM »
Hi
I have tried a few different post processors in Fusion 360 to work properly with mach3. But I have one issue that I think shouldn't be.
When the job is finished and it goes back to xyz 0 it starts with z0 and then xsnd y 0. This makes the surface get scratch when.
Is there someone that know of a post for fusion 360 that will prevent it doesn't scratch the piece when it goes back to zero?
Cheers
I have tried a few different post processors in Fusion 360 to work properly with mach3. But I have one issue that I think shouldn't be.
When the job is finished and it goes back to xyz 0 it starts with z0 and then xsnd y 0. This makes the surface get scratch when.
Is there someone that know of a post for fusion 360 that will prevent it doesn't scratch the piece when it goes back to zero?
Cheers