Hello Guest it is March 28, 2024, 01:30:49 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - doorman

Pages: 1
1
Hey guys,
I have a problem with the machine making a radius when it should be a hard 90 deg. turn.  It seems to only be when the machine goes from +X to -Y. 
I have played around with the velocity settings and it seems that the error gets greater as the velocity increases.
I have used the same program block by block and it works fine.
Any suggestions??

Pages: 1