Hello Guest it is April 12, 2021, 07:24:43 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - lkigam

Pages: 1
1
Hellow im trying to sell my blue Integrea HICON board with plasma hole software and ebay is asking me for the Manufacture Number do any one know it thanks

2
Mach4 Videos / MACH4 HICON INTEGRA
« on: September 04, 2017, 03:41:08 PM »
HI do any one have screen shots of how to set up the inputs and outputs on mach4 and Integra board I don't understand the manual how to set up the board to be able to use the motors I have a plasma table but I don't think that is a difference I can't make any of my motors move I'm using micro steppers drivers after the Integra they light up but no luck moving the motor thanks,
screen shot will be great thanks

3
Mach4 Toolbox / MACH4 tool change
« on: August 21, 2017, 03:25:53 PM »
Hi i'm new to mach4 and cant find how to fix this problem anywhere so hope some one can help me
i have a plasma table and using mill

MACH give me this window when i try to run my gcode

A tool change has been requested via
M6. Change your tool then press
Cycle Star to continue

well i dont know where or what to do
the gcode run with no problem on mach3

i'm using a Hicon integra board
thanks

Pages: 1