Hello Guest it is November 28, 2021, 07:44:14 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - georg schamberger

Pages: 1
1
Hi everyone,

I've got a problem.
I activated auto tool zeroing in mach3 with a tool length sensor.
the problem now is, that even the tool zeroing macro respects the override/ feed rate. so, of course, the Z value depends on the feed rate, as the computer and mach3 need some time to react on the sensor.
As I am a fan of foolproof solutions :-) I want to tell the macro to ignore the override/ feedrate. In case of need it would be possible to include the command to reset feed rate to 100%.

is that possible?

many thanks in advance and best regards

Georg





Pages: 1