Hello Guest it is March 28, 2024, 06:39:37 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - jetxcc

Pages: 1
1
General Mach Discussion / Mach3 & Aspire tool paths not the same
« on: April 12, 2016, 02:08:36 AM »
Hello all,
I'm sincerely hoping someone can help me figure out why my toolpath that i created in aspire will not load and cut out the way it is intended. the aspire preview shows that everything is as it should be, but when i load the toolpath file into Mach3 only a portion of the text comes through. The cutout and the profile toolpaths come through fine, but the V-Carve toolpath does not. Has anyone else had this happen? and if so, how do i fix it? this is my second attempt to post this after trying to post screenshots. so this is the abbreviated version, if you need more info just ask, I'll gladly go into more detail. Thank you in advance.

Pages: 1