Topics

1

General Mach Discussion / switching from CNCpro to MACH3

« on: March 28, 2016, 05:25:00 PM »

Our business has recently upgraded to a new computer that runs our shop CNC. We are switching from using CNCpro running on windows 98 to MACH3 with windows 7.  The problem now is that MACH3 will not communicate with the gecko drives to drive the motors (both have been replaced/upgraded in the past year).  I have checked all the port settings, and searched all over the forums for an answer but not found anything. All step/setting information/configurations were for the most part copied from the older computer. Does anyone have any ideas?