Topics

1

Mach4 General Discussion / Mach 4 Reference sequence Question

« on: November 11, 2018, 04:49:26 AM »

Hi,

is there any possibility to get a output signal from Mach4 who shows the status if the Machine is referenced on all axis?
I have a Signal Pillar which shows me the State of the Machine, if it is Enabled, a ToolChange is needed or if it´s in EStop Condition.
But i don´t know how i can get the Status of a Complete Reference Sequence. Single Axis Referenced signals are easy.


hope someone can help me


Thanks Sven