Hello Guest it is February 23, 2020, 06:43:14 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - pohare1

Pages: 1
1
General Mach Discussion / Lazyturn Problems
« on: March 09, 2016, 08:11:56 AM »
Hi all

I am using Lazyturn for my SEIG C6 CNC lathe

Everything is working fine, and i can get the machine to run accurately, however when the machine goes to run the finishing path is cuts to far into the profile.

It is as if it is getting Radius and Diameter mode mixed. I have tried different combinations of radius and diameter mode but the same problem exist

also when I run in Radius mode, the rough and fine paths match up but the first pass takes a huge chuck out of the material. ( at the minute im using dowel to test, if id run metal it would have been a disaster )

Any help would be greatly appreciated, as im fresh out of ideas.

PS

In the machine control software G8 and G7 are not supported commands

HELP!!!!!!

Pages: 1