Hello Guest it is May 17, 2021, 12:47:12 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - raymondbyrd

Pages: 1
1
General Mach Discussion / Master Axis and Slave Axis out of sync
« on: February 26, 2016, 03:15:06 PM »
Let me preface by saying I am an extreme novice with CNC software. I purchased a routing table with mach3 yesterday off of craigslist and was able to get it to run ok, but have been plagued by a slave axis that is about a second behind the master axis. I have been through different pages on this forum already in an attempt to solve the problem but so far have been unable to do so. Any help I could get would be immensely appreciated.

Pages: 1