Hello Guest it is October 22, 2019, 05:36:16 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Jasongib

Pages: 1
1
Share Your GCode / 90 degree sharp turns
« on: February 22, 2016, 12:55:15 PM »
Hello,

Hope someone can advice me please.

I'm new to this, got my machine setup and calibrated.

I'm trying to do a square but my corners are being cut slightly rounded. I would like them to be 90degree turns.

If there anyway to do this properly?

I'm using DevFoam pro and Mach 3.
Thank you

Pages: 1