Hello Guest it is March 28, 2024, 08:17:45 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - kminnaar

Pages: 1
1
General Mach Discussion / Y axis not moving or power up
« on: February 01, 2016, 09:14:19 PM »
Hi I am Kobus Minnaar and new to CNC. I building a CNC but got a problem and don't know if this is hardware or software. I send my Board a TB6560 3 axis to a electronic store and pay more to repair than i paid for it and still not working. My X axis and Z axis work correct and the led light come on when you power it up but the Y axis is dead, When you power it up there is nothing. They fitted a new Driver but it dont seem to be it. Is there any way to test the incoming signal to see if it power the drivers up

Pages: 1