Guest
Show Posts
1
General Mach Discussion / Strange problem with circles
« on: January 26, 2016, 06:50:17 PM »
Hi,
I have been using mach3 for a while now originally on a home designed and built wood router, recently I upgraded and Brought an ooznest OX which I am really happy with. I do have a strange problem, I use Artcam Express for most of my path generation, if I produce a simple square inlay the parts fit perfect, if however I use curves the don't can anyone suggest where I should start looking, simulation shows the Artcam paths to be accurate, I can only assume it is a setting in Mach but not sure where to look.
Any ideas greatly received
Tony
I have been using mach3 for a while now originally on a home designed and built wood router, recently I upgraded and Brought an ooznest OX which I am really happy with. I do have a strange problem, I use Artcam Express for most of my path generation, if I produce a simple square inlay the parts fit perfect, if however I use curves the don't can anyone suggest where I should start looking, simulation shows the Artcam paths to be accurate, I can only assume it is a setting in Mach but not sure where to look.
Any ideas greatly received
Tony