Hello Guest it is May 12, 2021, 02:53:31 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - bigal11

Pages: 1
1
General Mach Discussion / Z limit switch triggered
« on: January 22, 2016, 11:38:52 AM »
Hello all,
I'm having some trouble with the z axis limit switch being triggered when i start a toolpath. I set my home limits. everything is fine. When i start a toolpath the spindle moves up untill it hits the limit switch, stops and then i have to press reset to continue the toolpath. I tried debounce up to 5000 with no luck. This has only been happening for about a month now.
Any help would be appreciated.

Al

Pages: 1