Guest
Show Posts
1
General Mach Discussion / Jogging vs G1
« on: October 25, 2005, 10:37:14 PM »
OK I'll start by saying that I know I've done something wrong. I just cant figure out what it is..
I have an axis, configured and tuned such that I can jog at 6m/min.
If I try to move it using g1 in a program, it stalls at 3m/min.
I've checked that the jog speed is at 100%
I've tried inverting the logic of the step pin.
I'm running Mach3 Mill, Engine R1.83.003
Accelleration is low.
Any thoughts
I have an axis, configured and tuned such that I can jog at 6m/min.
If I try to move it using g1 in a program, it stalls at 3m/min.
I've checked that the jog speed is at 100%
I've tried inverting the logic of the step pin.
I'm running Mach3 Mill, Engine R1.83.003
Accelleration is low.
Any thoughts