1
General Mach Discussion / License Problem
« on: February 21, 2016, 12:06:29 PM »
I had some problems getting started because my chinese 3040t came with a software disk (mach 3) that I thought was an installation programme for the machine. I had already purchased a real licence and had the correct mach 3 software installed. After help from you guys on the forum I finally got everything running fine (I thought). Everything was fine today until halfway through my first project the cnc began cutting small circles (gutted) I could`nt figure out what could be causing this until I noticed that at the top of the screen mach 3 said DEMO. I have re installed 3 times today,m making sure thatv I removed all previous versions, then I re installed as per instructions and copied license data etc. Every time I restart my project I get about halfway through and then it goes wrong and mach 3 says I am using the DEMO. My questions are; What can make the license disappear during use? and how can I prevent it from happening? so long as my name appears at the top of the mach 3 screen as licensed to everythings fine. As soon as it changes to Demo the cnc starts cutting circles?
Thanks for reading and any advice you can give.
Thanks for reading and any advice you can give.