Hello Guest it is April 21, 2019, 10:40:15 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - arturod

Pages: 1
1
PoKeys / New Keypads for PoKeys
« on: April 29, 2010, 12:02:02 PM »
We are now offering new Keypads and other resources for PoKeys panels: http://www.cnc4pc.com/Store/osc/index.php?cPath=54.

I have seen a lot of questions on how to setup pendants.  Probably the instructions on setting this stuff will answer some of the questions.

Arturo Duncan
http://cnc4pc.com

2
Promote and discuss your product / Multifunction CNC Board
« on: July 05, 2006, 07:53:19 PM »
This new board comes with many of the features of the other boards that I have been offering.  I believe users will find they will save time and reduced wiring as it already comes with many built in features.  It is also great for use in systems that are already in place since it comes with a DB25 connector for output. 

Check out the board at:

http://www.cnc4pc.com/Multifunction_CNC_Board.htm

The features of this board are:
• Fully optoisolated
• Built-in Safety Charge Pump.
• Built-in Variable Speed Control.
•Built-in 10 amp AC Solid State Relay.
• Built-in 8 amp Solid State Relay with NO and NC positions.
• All pins can be used in a concurrent manner.
• Buffered outputs.
• Status LEDs on all inputs and output connections.
• Has an extra DB25 female connection for output.
• Output pins 1, 2, 3, 4, 5, 6, 7, 8, 9, 14, 16, 17.
• Input pins 10, 11, 12, 13, 15.
• Input and output pins with close by ground connections.
• Easy installation of an On/Off switch. You can control the card externally.
• All TTL 5VDC signals.
• Works directly with popular CNC hardware and software.
• Screw-On connections for all terminals.

Arturo Duncan
http://cnc4pc.com


Pages: 1