Guest
Show Posts
1
General Mach Discussion / Parker ACR9000 and Mach3
« on: December 31, 2015, 07:56:26 AM »
Hi,
I have commercial X/Y table, which is originally designed for another use than CNC.
System based on Parker ACR9000 controller and Aries AR-04 drivers + servo motors.
System not support control over parallel port and therefore looks that it's a bit tricky to control system with Mach3.
ACR9000 support ethernet, USB and serial cable and with Parkers own control SW, I can move table, so basically system is functional in the electrical point of view.
Is there any ideas, how to control ACR9000 with Mach3?
I have commercial X/Y table, which is originally designed for another use than CNC.
System based on Parker ACR9000 controller and Aries AR-04 drivers + servo motors.
System not support control over parallel port and therefore looks that it's a bit tricky to control system with Mach3.
ACR9000 support ethernet, USB and serial cable and with Parkers own control SW, I can move table, so basically system is functional in the electrical point of view.
Is there any ideas, how to control ACR9000 with Mach3?