Topics

1

General Mach Discussion / need help with MPG

« on: January 21, 2016, 11:07:27 AM »

Hello all I am a new b and looking for some information. I have an older PC-2-Route Model M2 V1.9 board made by sound logic that I am using to interface with my router. I have look for a manual for this but I guess its to old. It has a 6 pin connection on it for a mpg and i was hoping some one could help me figure out hot to hook it up. The mpg has 5V,0V,A,B, on it ( A&B are square waves output) it also has control for .001 and .010 on it. My questions are how to i figure out how to hook up what wires to the pins and then can i use one of the plug in to run this or will I have to wright my own brain to run it.

here  is a pic of my mpg

O posted this once but not sure if i did it right. trying again.

Thanks for any help Tom

2

General Mach Discussion / keyboard control

« on: December 29, 2015, 06:07:13 PM »

hello
 I am having a strange problem with my keyboard arrows and controlling my gantry. The up and down arrows are moving my x axis and right and left are moving my y axis. If I use the tab key to bring up the control panel it is moving correctly. (Z+ Z- Ect.) I have tried to reassign the hot keys and even tried assign them backwards to see if this would change the problem. I not sure if this is just a bug with Mach what. Everything else runs fine. Just wonder if anyone has run across this.

Thanks for your help.
 Tom