Hello Guest it is March 28, 2024, 05:30:24 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Dirk_H

Pages: 1
1
General Mach Discussion / Mach 3 vs Mach 4
« on: December 20, 2015, 04:15:58 AM »
Hello,

a friend of mine is planning to upgrade his china cnc to mach. The gantry style cnc mill is going to be used also comercially and has at least tool length compensation probe and automatic tool changer (ATC).

The question is: Use Mach 3 or Mach 4?

At the moment I found much support material and also sample scripts for ATC and tool length probe for mach3. I was not able to find anything for Mach4 yet. Just some small stubs in the forum, where I see much work to do - whereas the Scripts for mach3 seemed to be more or less complete.

I like the GUI of Mach4 looking a bit more "clean" and I think that VB is dead in 2015, this is what would convince me to go with mach4.
But I fear that I'd take MUCH longer to get everything (espcially ATC, probing, vfd programming, handwheel) running due to the lack of sample scripts and so on. Last but not least Mach4 seems to cost 2,5 times as much as mach3 for professional use..? At least at the german shop I looked at.

The planned controller is cs-labs  CSMIO/IP-S - 6 if this is of any concern.
I look forward to your thoughts. I dont expect anything like "go with 3 / 4 in every case" but I'm looking for your comments/thoughts.

Thank you so much in advance
Dirk_H

Pages: 1