Hello Guest it is March 28, 2024, 08:01:11 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Nutz-n-Bolts

Pages: 1
1
Hi All,

After my first post here I've abandoned ideas of trying to use a Mac to run my Mach retrofitted mill.

See old post:   www.machsupport.com/forum/index.php/topic,31444.0.html

Gerry was kind enough to suggest a UC100 motion controller in combination with a C10 breakout board which seems like they would do, but one answer always seems to breed three more questions.


This machine has the usual X,Y & Z axis with limit switches.  Additionally this machine has air actuated spindle brake and air actuated spindle speed adjustment, as well as high and low range gearing for the spindle. Then there is also the Bijour lube pump.   Because of the air actuation there would be two separate electrical circuits for each function.  For spindle braking on & off ,and for spindle speed up and down. The high and low range may require some type of sensor circuit too. My question is will the C10 be enough to handle all of these functions?  I don't mind spending a little extra to get the right hardware. Perhaps an integrated motion controller and BOB ?http://


Secondly I've read some debate on Mach4 versus 3.  Seems that Mach 4 is coming along and being a novice machinist I probably won't be needing much of the higher functionality I hear it's lacking compared to Mach3. Should I just start out with 4?  If so does anyone have recommendation on a PC that works well with Mach 4?  (or Mach 3 if you think I should swing that way)  Again I'm not just looking for a bargain basement PC I'm more interested in reliability.


I should mention that I'll be using Slo-Syn SS200D6 drivers.  I just picked up two of the three that I'll need.  Oh, and I may want a 4th axis some day, but even a basic C10 has 4 axis capability.

2
Hey Gang,
  I Have a  Bridgeport Series1 BOSS 5 Mill.  It's still all original but the "computer" is dead.   I would like to retrofit this unit with Mach3, some Slo-Syn SS2000D6 drivers for the stepper motors, and then use a Mac Mini to run it all.  I'm trying to keep windows computers out of our home.   Using a Mac Mini, I must use the USB output rather than parallel port.  This leads me to wander weather or not I need a motion controller or break out board?  Also do the Slo-Syn drivers need a motion controller or just a standard break out board?  I also really don't know that much about the break out boards and see them from 10 bucks on Fee-Bay to $79 at what seem like much more trustworthy sites.

 Which should I use motion controller or BOB?  AND  Is there one that will work better using Apple OSX ?

Pages: 1