Topics

1

LazyTurn / Mach3 work with a Gerber Sabre 408 router Table

« on: July 13, 2016, 07:00:13 AM »

I was wondering if anyone on here knows whether or not after Mach3 is install on PC can it be connected to a Gerber Sabre 408? The Gerber Sabre does read g-code, Cause I already have Artcam Express Software installed on the PC. and it is connect to the parallel port going to the electrical cabinet of the machine. But I want to install Mach3 as well to be able to send other jobs done on other 3d modeling software

2

General Mach Discussion / mach3 run from here?????

« on: December 05, 2015, 09:38:57 PM »

Is there a way to stop in the middle of running mach3 and adjust the z axis ( or adjust the depth that im cutting at). and then continue cutting with my cnc? I'm cutting out detailed design logo's into wood. Sometimes the wood is slightly warped and half way through the job, I need to ne able to pause and set the depth or (z). Ay help would be great.