Guest
Show Posts
1
General Mach Discussion / Z-axis Locked
« on: December 03, 2015, 01:07:09 AM »
Whats up guys,
I am having problems with the z-axis being locked running mach3 on a dj3040 desktop router. The z-axis never unlocks after starting mach3 software, x and y axis unlock and move but the z stays locked and gets hot fairly quick. I have done everything with the cnc from check wires and connections and everything is good so I am guessing it is something that I accidently turned on or off or something but have went through it multiple time with no success. If I hook the z-axis stepper to say the x-axis control wire it works fine. SO DOES ANYBODY HAVE ANY ADVISE OR IDEAS?
THANKS IN ADVANCE
I am having problems with the z-axis being locked running mach3 on a dj3040 desktop router. The z-axis never unlocks after starting mach3 software, x and y axis unlock and move but the z stays locked and gets hot fairly quick. I have done everything with the cnc from check wires and connections and everything is good so I am guessing it is something that I accidently turned on or off or something but have went through it multiple time with no success. If I hook the z-axis stepper to say the x-axis control wire it works fine. SO DOES ANYBODY HAVE ANY ADVISE OR IDEAS?
THANKS IN ADVANCE