Hello Guest it is September 20, 2019, 04:22:02 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Z-BACK

Pages: 1
1
General Mach Discussion / Motor Tuning and Setup A-Axis
« on: December 02, 2015, 01:11:05 PM »
Hello All,

I have just received a new Rotary Axis for my DIY built CNC router.  I am needing help with the motor tuning setting for Mach3 for it.

I need:
Steps per:
Velocity:
Acceleration:
G's:
Step Pulse:
Dir Pulse:

Here are the specs:
Rotational Axis:

With K12 100MM 4 Jaw Centring Chuck
Center height:65MM
Total height:115MM
Motor:Nema23 2-phase 57 stepper motor
Motor Electric current:3A
Motor Voltage:3V
Motor Holding Torque: 1.35N/M
Step Angle: 0.3degree/step
Reducing ratio:6:1(Timing belt deceleration mode)
Synchronous belt:3M
Weight:8KG

Thanks in advance,

Pages: 1