1
General Mach Discussion / Converting from ncstudio
« on: November 14, 2015, 07:31:51 PM »
I need some help connecting mach3 board to vfd.
The new board has a spindle on/off and 0-10v PWM
the old board had 4 wires going to the vfd green - fwd and ACM
blue - M11
yellow - M12
red - M13
In ncstudio spindle speed was 2400, 1200 or off ( you could enter whatever speed you liked but it only did off, fast and very fast)
any ideas on how I wire this?
The new board has a spindle on/off and 0-10v PWM
the old board had 4 wires going to the vfd green - fwd and ACM
blue - M11
yellow - M12
red - M13
In ncstudio spindle speed was 2400, 1200 or off ( you could enter whatever speed you liked but it only did off, fast and very fast)
any ideas on how I wire this?