Hello Guest it is March 28, 2024, 11:19:14 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - maxaircarbs

Pages: 1
1
General Mach Discussion / Need dedicated cycle start
« on: June 22, 2017, 08:34:19 AM »
OK.  So I am frustrated.  Not sure if this is the right category. 
Here goes.  I am quite sure this is a very old subject and very easy to do.  ..but.. I have an older i-pac that works fine and have married some functions already to it but I want to also do a cycle start.  I see the way to do this come off the Bob and use an Oem codes but I want to save the inputs for other features later down the road so feel I could get this done with the i-pac.  The only problem is it seems the only way I can do this is change the hotkey for cycle start.  Everytime I download machscreen and try to run it it won't run as a file is missing or something.  So what am I to do?  Is there a machscreen file that works?  I am thinking I will be asked what version mach I'm running and I will have to look.  I think it's 3.4 or something. I also l as t night tried changing the hotkey on load g code to something generic and it doesn't want to work either.  All else is not a big deal I just simply want a cycle start button on my panel without using inputs on breakout board and using the i-pac. Also what file stores all of your settings in case computer crashed and I have to reload.
Thank you in advance

Pages: 1