Hello Guest it is April 09, 2020, 03:01:13 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - jdmyjak

Pages: 1
1
Galil / Trouble with RESET
« on: November 11, 2015, 08:01:54 AM »
Using Mach to control a DMC2140.
After startup in E-stop when I hit Reset the motors will twitch either right away or on a jog.
If I hit Reset and then in Galiltools issue an RS and SH (or hit Stop in Mach) I can jog away and run Gcode.

Pages: 1