Hello Guest it is March 28, 2024, 06:14:37 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Skoobizz

Pages: 1
1
General Mach Discussion / can't get spindle to work
« on: October 13, 2015, 02:17:47 PM »
My father and I have designed and built a new 4 axis CNC mill from the ground up in our machine shop. I'm a total newbie to Mach programs and have never tried to set anything like this up before. I have been able to get the X, Y, and Z axes to run on our mill but have had absolutely no luck with the spindle. For now all I want to do is to tell the spindle to turn on or off. I have gone through the manual and I have not been able to figure out what to do with it. can someone walk me through it?

Pages: 1