Hello Guest it is March 29, 2024, 07:01:19 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - robobass

Pages: 1
1
General Mach Discussion / Very strange bug
« on: October 02, 2021, 05:39:30 AM »
Hello everyone!
I have been using BobCad v26 with their Mach3Metric post processor for like 8 years without troubles. A few days however, something very strange started happening. Attached is a simple hole pattern. When I run it it makes a row of holes that aren't in the file. I also made a few other files where the tool failed to retract when it should. All .tap files I wrote before two days ago run as they should, and I haven't made any changes to the Mach3 configuration or settings or anything. Any ideas?

2
General Mach Discussion / Help with Huangyang VFD
« on: May 25, 2016, 07:55:20 AM »
I bought a router last year already set up with Mach3. I've been quite productive with it, but can't figure out how to alter the spindle speed. I have the manual for the VFD, but can't make anything from it. The spindle motor is supposed to run from 8k to 25k rpm, but so far I can only turn it on and off. The output .tap files from Bobcad26 also turn it on and off, but any speed information doesn't get used. Can anyone point me to some tutorials on how to set up a VFD with Mach3?
Thanks in advance

3
General Mach Discussion / Cut time estimation?
« on: October 08, 2015, 10:21:12 AM »
I'm running Mach3 on a generic 3x router. Any way to calculate the running time of a program short of actually running it?

Pages: 1