1
General Mach Discussion / Homing Position
« on: October 07, 2015, 07:53:21 PM »
I installed my homing switches based off of a couple mini mill examples on the internet.
Is the the correct position for "home?"
I am having trouble with the concept. When I ref all home, it goes to this position in my example picture. the thing I get confused about is when i jog away from its home position on the x or y, its a negative number.
because of this confusion its hard for me to figure out my soft limits.
i have watched the mach3 tutorial on home switches, twice so far....im still just a bit confused.
If anyone could help explain this to me or point me in the right direction id appreciate it!
Is the the correct position for "home?"
I am having trouble with the concept. When I ref all home, it goes to this position in my example picture. the thing I get confused about is when i jog away from its home position on the x or y, its a negative number.
because of this confusion its hard for me to figure out my soft limits.
i have watched the mach3 tutorial on home switches, twice so far....im still just a bit confused.
If anyone could help explain this to me or point me in the right direction id appreciate it!