Guest
Show Posts
1
Mach4 General Discussion / x-Carve Arduino USB w/GShield
« on: December 02, 2015, 12:35:38 PM »
Hey all,
Been on a fun ride this last month, building a CNC, learning Fusion360, Scrapping together a design and then i'm ready to test. Well, I couldn't get Mach4 to connect to my CNC... I didn't see anything that says Serial port connection.. A little bit of a look around the forums here, and there were only a few recent posts about this.. maybe something about an LUA script, there may at one time been a VB script for Mach3.
I thought I'd ask for a definitive 'As a Newbie' question.
Is there any support for the GShield/Arduino/USB connection type CNC Machines, or is there something I need to modify to get it to work with it.
Thanks.
~D
Been on a fun ride this last month, building a CNC, learning Fusion360, Scrapping together a design and then i'm ready to test. Well, I couldn't get Mach4 to connect to my CNC... I didn't see anything that says Serial port connection.. A little bit of a look around the forums here, and there were only a few recent posts about this.. maybe something about an LUA script, there may at one time been a VB script for Mach3.
I thought I'd ask for a definitive 'As a Newbie' question.
Is there any support for the GShield/Arduino/USB connection type CNC Machines, or is there something I need to modify to get it to work with it.
Thanks.
~D