Guest
Show Posts
1
General Mach Discussion / Stepper driver and Mach3 Question
« on: September 29, 2015, 08:09:08 PM »
Hello all.
I dug out a driver box I used some years ago that I built with Centent cn0143 drives and I cant get them to run properly in Mach3,
the steppers all run but only one direction no matter what key I use negative or positive direction. Last time I ran them I was using a Dos based program.
I also have another box I put together with Gecko G201 drives running Mach3 with no problems runs great. What am I missing ?
Thanks
I dug out a driver box I used some years ago that I built with Centent cn0143 drives and I cant get them to run properly in Mach3,
the steppers all run but only one direction no matter what key I use negative or positive direction. Last time I ran them I was using a Dos based program.
I also have another box I put together with Gecko G201 drives running Mach3 with no problems runs great. What am I missing ?
Thanks