Hello Guest it is October 17, 2019, 07:34:56 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - steveD

Pages: 1
1
General Mach Discussion / something has gone wrong !!!
« on: March 28, 2016, 09:24:01 AM »
I have been running the hicon integra with the mach3 for about 6 months. After the initial setup everything worked great, however I am having the issue now of the X axis getting off. at home the gantry is 1/16 off on the home side and when it travels about 4 feet it gets upto 1/4 inch out. I was thinking a stepper motor going out but when I tested them they are fine, I also checked the transmissions and belts for play and wear they are also fine. i then checked the drive output and the settings have not changed. does anyone have an idea of what this might be?

2
I am having an isue setting up me X,Y,Z limit switches in the mach3 softwear. im not 100% sure on which input in the software it would be but i do know from the documintation from integra the port is 11 and the pins are 0-3. can anyone please explain this for me. also I am having questions on what is the properway to do the spindal control.

Pages: 1