1
General Mach Discussion / HELP: Generate PWM signal for Spindle OFF in Mach3 (Brushless spindle/ESC)
« on: April 17, 2017, 04:58:55 PM »
Is there a simply (easy?) way to get Mach3 to generate a PWM pulse signal even when the spindle OFF?
On my setup, I have a brushless spindle powered by an ESC.
The problem in need of a solution is the ESC is expecting a pulse even for the OFF speed.
I am able to generate a PWM signal for when the spindle is on, but this is perplexing me.
Ideas?
On my setup, I have a brushless spindle powered by an ESC.
The problem in need of a solution is the ESC is expecting a pulse even for the OFF speed.
I am able to generate a PWM signal for when the spindle is on, but this is perplexing me.
Ideas?