Hello Guest it is March 28, 2024, 09:57:04 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - webdirector

Pages: 1
1
General Mach Discussion / Set JOG Mode to Cont.
« on: September 19, 2015, 01:29:25 PM »
Hello,

I installed Mach 3 and it has been working great. Just some small things ........

1- When I startMach3 Mill the JOG mode is always in "Step" mode. Is ther a way to set is so JOG mode would always be when started in "Cont." mode ?

2- In JOG Mode when I am in "Step" mode it moves only very slow Is there a place to adjust the speed ?

I know these are probably simple questions but I doi not seem to be able to find this

Thanks for support


Pages: 1