Hello Guest it is March 29, 2024, 09:09:37 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - masons forge

Pages: 1
1
General Mach Discussion / I can't scale any more
« on: September 04, 2015, 09:54:16 AM »
I'm running Mach3 and I have always been able to scale up or down by changing the values of the X-Y from 1.000 to what I need, until yesterday. I think I have hit a hot key to turn off scaling because on the second screen tab I see the label Scaling Off G50 beside the XYZ display. I'm using it to run a plasma cutter and I don't have a DTHC so I think I hit a button while babysitting the height. Please let me know iff you need more information to help with this problem. Thank you in advance.
Josh

Pages: 1