Hello Guest it is March 29, 2024, 10:04:19 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - moraykidz

Pages: 1
1
General Mach Discussion / Stepper motor problems
« on: September 14, 2015, 11:34:12 AM »
Hi, After all the problems I have had in getting this 4030 to run, 3 PCI cards only to find out that Mach3 does not run on a 64 bit pc AHHHHHHH, so purchased a 10 year old pc, connected it up and away it went. Brilliant i thought until I pressed the Pg up key on my keyboard for the Z axis to lift the bit up, Guess what happened, The bit went down and when you pressed the Pg down key the bit went up. My question is, Is this an easy fix, Can this be fixed using mach3 software.

Regards

Malcolm

Pages: 1