Guest
Show Posts
1
PoKeys / Mach3 and Pokeys Error Code 200702 and 9991
« on: August 24, 2015, 12:18:05 PM »
Dear Mach3 community
I have the following problem with the Mach 3 software .
I recently purchased the Pokeys56U . Now I wanted to configure it with my Mach3 and have for the plugin " Pokeys.dll " installed .
Now when I open Mach3 and the plugin under " Plugin Control " Configuriere , place of the Pokeys also . After Configuration says with Mach3 I need to restart the program . After the restart then comes but once an error message " Error triggred with the error number 200702 and 9991 "
Thereafter, the program crashes and I have to restart it. Then again the same error . Now I can start the program Mach3 only when I remove the USB cable from Pokeys .
Has any one of you a solution to the problem ?
Sorry for my english , I 'm from Germany
greeting
Timo
I have the following problem with the Mach 3 software .
I recently purchased the Pokeys56U . Now I wanted to configure it with my Mach3 and have for the plugin " Pokeys.dll " installed .
Now when I open Mach3 and the plugin under " Plugin Control " Configuriere , place of the Pokeys also . After Configuration says with Mach3 I need to restart the program . After the restart then comes but once an error message " Error triggred with the error number 200702 and 9991 "
Thereafter, the program crashes and I have to restart it. Then again the same error . Now I can start the program Mach3 only when I remove the USB cable from Pokeys .
Has any one of you a solution to the problem ?
Sorry for my english , I 'm from Germany
greeting
Timo