Hello Guest it is March 29, 2024, 09:56:44 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Larsaf

Pages: 1
1
Mach4 General Discussion / TouchOff UI
« on: January 08, 2017, 11:21:32 AM »
Hello,

I'm just reading the "Mach4 Touch Module" PDF and would like to know, what I have to do to use it. If I click the "Touch" button nothing happens  (engine is enabled). The probe is configured in Mach4 Input-Signals. Can anybody help me?

best regards from Germany
Klaus

2
Mach4 General Discussion / Strange behavior
« on: January 08, 2017, 03:59:52 AM »
Hello,

I've spent many hours to write a macro to import a .csv file but it doesn't work properly and I had no idea what went wong. ???

Eventually I noticed that the Lua I/O routines skipped lines that contain the german letter "ä". This letter appears in almost every line of the file because the german word for a milling tool is "Fräser". After replacing "ä" with "ä" (that's the string Mach4 use in tooltable.tls to represent "ä") everything went fine.

regards from Germany
Klaus

3
Mach4 General Discussion / Tool Table Import?
« on: January 05, 2017, 07:22:23 AM »
Hello,

my CAM can export its tool table as a .csv file. Is there a way to import this into Mach4? This could not only save a lot of typing but it also prevents from typing errors.

best regards from Germany
Klaus

4
Mach4 General Discussion / Stupid little question
« on: December 29, 2016, 04:01:24 AM »
Hello,

I'm from Germany and english is not my native language. When I looked at the different screen set I noticed that there is a screen for "routers" and a screen for "mills". Can anyone explain in a few words the difference between routers and mills.

best regards from Germany
Klaus

5
PoKeys / Mach4 V2 + PoKeys 57E
« on: August 21, 2015, 02:25:31 PM »
Hello everybody.

I'm new to this Forum and so at first I want to send regards from Germany to you.

Today I installed Mach4 V2.2640 but when I tried to install the PoKeys plugin I received an error message. It said the Firmware of  the 57E needs to be updated but I'm using the latest firmware. With Mach4 V1 I had the same issue and had to'downdate' to firmware v3.1.52 to get Mach4 V1 to work but not with Mach4 V2. :'(

Does anyone use Mach4 V2 with PoKeys 57E? If so - please tell me which Versions.

best regards from Germany
Larsaf

Pages: 1