Hello Guest it is December 04, 2021, 08:51:25 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - DonKijote

Pages: 1
1
Hello everyone this is my first post here.

I am troubleshooting this mill, using gecko 320x and a smoothstepper board, with a power supply kit from automation technologies.

Motors heat up very fast when on idle, and when i try to jog continually i get steps, even with the MPG i still dont get continuous movement. and sometimes it goes the opposite direction a couple of steps.

Any ideas?

Thanks
-Ed

Pages: 1