1
General Mach Discussion / slave axis aleatory movement
« on: August 14, 2015, 05:47:48 AM »
Hi Guys a newbie question!?
Mach3 in windows XP, X+A axis together in (config->slave axis).
When using arrow keys they are responsive but, one of the axis run OK, the other goes aleatory in both directions.
And in MPG mode when adjusting "slow jog rate" less than 50% the motor in case just shake..
Anyone could help me in this situation, please?
regards,
Marcelo
Mach3 in windows XP, X+A axis together in (config->slave axis).
When using arrow keys they are responsive but, one of the axis run OK, the other goes aleatory in both directions.
And in MPG mode when adjusting "slow jog rate" less than 50% the motor in case just shake..
Anyone could help me in this situation, please?
regards,
Marcelo