Guest
Show Posts
1
General Mach Discussion / Used EStop and now steppers aren't working
« on: July 18, 2015, 08:31:26 PM »
Hello all,
I'm hoping I can get some help here.
I've been running Mach3 for a while now, but just today needed to use my EStop button.
After I did, I now cannot get my steppers to run.
I can hit the reset button and it stops blinking. I have untwisted the Estop button. Nothing is working.
I'm using the GeckoDrive G540 and noticed that the fault light is on. I believe usually there is a green light on.
Any advice on where I should begin?
Any help is greatly appreciated.
Best Regards,
Blain
I'm hoping I can get some help here.
I've been running Mach3 for a while now, but just today needed to use my EStop button.
After I did, I now cannot get my steppers to run.
I can hit the reset button and it stops blinking. I have untwisted the Estop button. Nothing is working.
I'm using the GeckoDrive G540 and noticed that the fault light is on. I believe usually there is a green light on.
Any advice on where I should begin?
Any help is greatly appreciated.
Best Regards,
Blain